MTF-Huawei Module 1.0 – Sigmakey Needed

A small program called MTF-Huawei Module 1.0 was developed to format Huawei devices in a number of ways and resolve problems like factory resets and FRP. However, the SigmaKey software is required in order to use this module. You won't be able to complete all the tasks without this software.

We would especially like to thank Monkey D. Cell and Warriors-GSM for providing this module.

Action Plan: FRP Reset and Fastboot Format

The purpose is to use MTF-Huawei Module 1.0 to reset the factory reset process on a Huawei device. However, sometimes the device may continue to show the logo or become stuck even after completing a format. In such cases, additional steps are required to remove FRP and ensure the device is fully reset.

Step-by-Step Guide

Test 1: FRP Reset and Fastboot Format

Prepare the Device:

• Put your Huawei device into Huawei COM 1.0 mode via the test point method using a modified USB cable.
• This allows your SigmaBox to communicate with the device at a low level.

Open SigmaKey:

• Launch SigmaKey on your computer.
• Select the following options:
  • Platform: Hisilicon
  • Port: Choose the correct port corresponding to the connected Huawei device.
  • Processor: Kirin

Load Fastboot:

• In SigmaKey, select Load Fastboot.
• Wait for the system to establish the fastboot connection.

Open the MTF-Huawei Module 1.0:

• Once the connection is successful, open MTF-Huawei Module 1.0.

Perform Fastboot Format:

• On the MTF-Huawei Module, press 2 to initiate the fastboot format process.
• Wait for the process to complete.

In case the device logo is still visible:

• If the logo remains after the format, enter Recovery Mode and perform a low-level format.

Step 2: Recovery Mode Format

If the device is still stuck, follow these additional steps:

Put the Device into Huawei COM 1.0 Mode:

• Reconnect the phone using the test point method with the modified USB cable.

Reopen SigmaKey:

• Launch SigmaKey again.
• Make sure to select the same settings as before:
  • Platform: Hisilicon
  • Port: Correct port for the device
  • Processor: Kirin

Load Fastboot:

• Choose Load Fastboot once more to re-establish the fastboot mode connection.

Remove FRP:

• On the SigmaKey interface, select Remove FRP.
• Wait for the tool to proceed with the FRP removal.

Wait for the Process to Finish:

• Once the FRP removal process is completed, your device should be free from the Google account lock (FRP).

Download Link

Download from JioCloud

File Password:

By: Warriors-GSM & Monkey D. Cell